At the end of December, popular tipster Steve Hemmerstoffer shared a CAD render of the Huawei P50 Pro. It only gave a glimpse of the front design of the smartphone. He is now back with fresh renders to showcase the front and rear design of the P50 Pro.
Starting from the rear, the Huawei P50 Pro features a glass back and a metallic frame. The top and bottom flat edges that can be seen on the device are similar to the ones found on other Huawei phones such as Mate 30 series, P30, and P Smart 2021.
There is an oval-shaped camera module on the backside of the Huawei P50 Pro. A close look at the camera housing shows that it has two circles inside it along with an LED flash. The camera lenses are not shown in the CAD renders. It is likely that the two circles could be housing around four cameras.
The handset measures 159 x 73 x 8.6mm and its thickness increases to 10.3mm at the camera bump. Moving to the front, it features a 6.6-inch display with curved edges that are not very prominent. As it can be seen, it is blessed with ultra-thin bezels.
The Huawei P40 Pro’s screen featured a pill-shaped selfie camera cutout at the upper-left corner. It housed the main camera and a ToF lens. The CAD renders show that the Huawei P50 Pro has a single selfie camera, which is placed at the top-center position.
The Huawei P50 Pro’s OLED panel is integrated with a fingerprint scanner. The top edge of the phone has a speaker and an IR blaster. Another speaker can be found on the bottom edge of the device. Rumors are rife that the Huawei P50 series will go official on April 17.
RELATED:
- Huawei P50 series tipped to be the first Huawei model to run HarmonyOS out of the box
- Huawei to unveil its flagship 5G tablet alongside the P50 series next month
- Sony IMX800 will be the first 1” mobile camera sensor and it will appear in the Huawei P50 series
